05
6. GETTING STARTED
BOOST - To set up the Level Boost, plug your instrument into the Input jack (6), and con-
nect the Output jack (7) to your amplier. Turn the eect on using the left footswitch (4),
making sure the LED is ON (this indicates that the eect is active). Next, adjust the Level
Boost knob while toggling the footswitch (4) on and o, comparing the volume of the
direct signal (light o) with the boosted signal (light on). Match the gain level as closely
as you can to the direct signal, then adjust the Level Boost knob to the desired amount of
added gain or cut. A suggested use of the boost is to leave it turned o until it’s time to
solo, then switch it on (4) for a quick level boost when you begin your solo. You can easily
apply this to ANY situation where you need two dierent, quickly accessible playing
volumes.
FILTERS - To audition the lters, rst step on the right footswitch (5), making sure the LED
is ON (indicates that the eect is active) and with the lter knobs (2 and 3) in o position
(counter-clockwise). Next, dial them in gradually one at a time to discover what eect
they have, comparing the unmodied signal (light o) with the modied signal (light on)
while toggling the footswitch (5) on and o. Explore them separately rst—but you may
nd that using both in combination can lead to some very appealing and musical results!
Mark your own preferred settings on the User Setting Chart below.
7. TECHNICAL SPECS
INPUT IMPEDANCE: 300 Kohm
OUTPUT IMPEDANCE XLR: 600 ohm
OUTPUT IMPEDANCE LINE: 100 ohm
POWER REQUIREMENTS DC INPUT: +12VDC
DIMENSIONS: 140 x 105 x 60 mm
5.5” x 4.1” x 2.4”
WEIGHT: 475 g
1 lb
8. GRAPHS
VPF (max)
-20.00 dB
-15.00 dB
-10.00 dB
-5.000 dB
0.00 dB
5.00 dB
10.00 dB
15.00 dB
10.00 Hz
100.00 Hz
1.000 kHz 10.00 kHz 100.00 KHz
VLE (min-max)
-40
-30
-20
-10
0
10
20
30
10 100 1000 10000 100000
Frequency - Hz
dB
CLEAN SOLO BOOST
OLDSCHOOL NO BOOST
SLAP SOLO
BIG BASS BOOST
USER SETTING CHART MAKE UP YOUR OWN!
RECOMMENDED SETTING IDEAS
Comments to this Manuals